Bike power: version 2 – field test

Bike power complete. Bike, bike stand, 3 phase rectifier, capacitor,  6 Amp solar battery charge controller, 12V bulb.

Bike power complete. Bike, bike stand, 3 phase rectifier, capacitor, 6 Amp solar battery charge controller, 12V bulb.

The bike ( on a bike stand ) were attached to the 3 phase rectifier and the 1 Farad capacitor to produce 12V DC.

The wheel is a  200 W 36V wheel so the bike could only be operated at a low ( comfortable) speed to prevent too much voltage and too much current.

A 12V 50W dichroic light bulb was added to show it was really working.

capacitor at 13.6 Volts and 50Watt 12 Volt dichroic light working.

capacitor at 13.6 Volts and 50Watt 12 Volt dichroic light working.

PV charge controller added using the bike as the power input instead of the solar panel and battery charger was used.

Probably best for charging a small device unless you want to pedal the bike for a long time.

Future additions:

36 to 12 volt step down for a higher current lower voltage system.

replace the back tire with a smooth tread tire.

Advertisements

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s